Contact Us

TEL:0595-22990366

E-mail:heyi-frank@heyitech.com

HEYI Building NO.63-1 Yu Shi Road, Economic and Technologic Development Zone, Quanzhou, Fujian, China

Home > Exhibition > Content
HY-W20 ALARM SYSTEM CMS SETTING
Jun 15, 2018

     

HY-W20 ALARM SYSTEM CMS SETTING

 

1. Put the SIM card into SIM card slot (side of alarm panel)

2. Await the panel initialize and connect to GSM network. (Under standby status, short press "1111.png", entering the GSM module status instructions. Indicator light turns to Long bright, it stands for GSM works normally; quick flashing for GSM fault or initialization failure; slow flashing for weak/no signal.)

3. Connect the alarm panel with APP (for specific operation please go through the manual book)

4. Set CMS Option under APP

a. Set APN information (provide by your local mobile operator)

2222.png  

b. Set communication information of alarm receiving center

 3333.png

5. Await the panel connect with the Serve. (Under process of connecting GPRS, short press "1111.png", entering the GSM module status instructions, and then short press "9999.png" or "10000.png" to query the status of GPRS. Long bright stands for successfully connect with CMS; quick flashing for connecting with mobile network; slow flashing for disconnecting with mobile network.)

 

 

 

 

 

After finishing setting on HY-W20, turn to set on CMS alarm receiving center.

 

CMS ALARM RECEIVING CENTER SETTING

 

4444.png 

1. Input Account name and password (Default account: Admin, password: A)  Awareness: Capital or small letters

2. Click "Log in" to access the system

 

5555.png 

1. Select menu --- system configuration---communication configuration

2. Set CMS IP address

3. Set CMS communication port

4. Click "save" button and close the current window

 

 

 

6666.png 

1. Select menu --- account management---account search---unknown account

2. Click "fresh" button to refresh till information of the panel appears in the list

3. Select the one you need

4. Click "add" button

 

7777.png 

1. Select menu --- User information---device info.

2. Set communication module operation password, the numerical value is the latter four digit of program password of the panel. (Default:8888)

3. Set arm and disarm command, the numerical value set as 01#, 03#

4. Click "save" button and then close the current window

 

8888.png 

1. Await the panel get online

2. The panel connects successfully if the symbol (showed as above) appears.

3. Hereto, finish adding device


Previous: Pay Attention to Home Security; Installing GSM Alarms Seems Indispensable

Next: Smart Security System Settled in Home, 24 hours to Protect User Safety